The amplified number of buildings being erected across North Carolina is astonishing. Business and residents are in the need to expand or build more space. Many have looked to SouthEastern Erectors to design and construct a steel building of the highest quality and considerably lower in cost than traditional construction. A steel building is safe, secure, and budget friendly. For over 30 years, SouthEastern Erectors has pleased hundreds of customers.

A question that we have been asked many times, “What components does a steel building consist of?”  Whether your steel building is erected in North Carolina or somewhere else, the components do not vary, but not all components are used in every project. We inspect every component before installation for defects or weaknesses. The particular components your building will use and how many of each depends on the design and engineered plans. Before construction begins, the plans must be approved for municipal building code compliance.

  • Channels – this is a component formed from a steel sheet shaped as a block “C”. it is used singularly or back to back, while supporting vertical or horizontal loads.
  • Eave Struts – positioned at the eave of a building which supports roof and wall paneling
  • Canopies – overhanging roof structure with the farthest end usually unsupported
  • Girts – A horizontal structural component supporting vertical loads and may consist of several pieces.
  • Framed Openings – used to open portions of a wall that will be used as an access point. The name refers to the framing members and flashing surrounding said opening, which also include: Jambs, Header or Sill, Trim, and fasteners.
  • Purlins – a horizontal component used for roof support. Shaped like a “Z”
  • Mansard/Facade – decorative trim or panel system jutting out from the face of a wall panel.
  • Wall Panels – comes insulated or non-insulated, load-bearing
  • Metal Studs – component used for various framing systems, often in place of wood studs.
  • Parapet Walls – same as mansards/facades except parapet walls do not have projection.
  • Partitions – used for inner wall system to section of portions of interior space, which must run the to the roof line.
  • Purlin Extension – overhanging or projecting roof structure with the far end usually unsupported. Typically used for aesthetic application or to cover driveway or walkway.
  • Linear Panels –
  • Roof Panels
  • Weatherroof – metal standing seam roofing component attached to sub-framing using concealed, interlocking clips that provide for minimum penetrations.
  • Angles – bent at a right angle used for joining and reinforcing two structural members

SouthEastern Erectors is well versed in every component available to insure your steel building is exactly like you want it and is safe, secure, and of unsurpassed quality. Call the foremost North Carolina steel building contractor today to construct the steel building you deserve. 888-636-6193